EMT Practice Test

1. Question Content...

---

Question1: What are two ways in which automatic MAC address quarantine works on FortiSwitch? (Choose two.)

Question2: Which two statements about managing a FortiSwitch stack on FortiGate are true? (Choose two.)

Question3: Refer to the exhibit.

The exhibit shows the current status of the ports on the managed FortiSwitch. Access-1.
Why would FortiGate display a serial number in the Native VLAN column associated with the port23 entry?

Question4: Which two rules used by MSTP are similar to rules used by other STP methods? (Choose two.)

Question5: Which Ethernet frame can create Layer 2 flooding due to all bytes on the destination MAC address being set to all FF?

Question6: Exhibit.

The exhibit shows the current status of the ports on the managed FortiSwitch.
Access-1.
Why would FortiGate display a serial number in the Native VLAN column associated with the port23 entry?

Question7: Refer to the exhibits.


Port1 and port2 are the only ports configured with the same native VLAN 10.
What are two reasons that can trigger port1 to shut down? (Choose two.)

Question8: How is traffic routed on FortiSwitch?

Question9: Refer to the exhibits.


You are asked to ensure that managed FortiSwitch devices are reachable by other devices, such as SNMP and other management tools across your network.
Which setting must you configure to ensure traffic from other devices in the network reaches FortiSwitch?

Question10: Which QoS mechanism maps packets with specific CoS or DSCP markings to an egress queue?

Question11: How does FortiGate handle configuration of flow tracking sampling if you export the settings to a managed FortiSwitch stack with sampling mode set to perimeter is true?

Question12: Exhibit.

port1 and port2 are the only ports configured with the same native VLAN 10.
What are two reasons that can trigger port1 to shut down? (Choose two.)

Question13: Which feature should you enable to reduce the number or unwanted IGMP reports processed by the IGMP querier?

Question14: Which statement about the quarantine VLAN on FortiSwitch is true?

Question15: In which two ways can you assign a FortiSwitch port to a VDOM using multi-tenancy setup? (Choose two.)

Question16: Refer to the exhibits


Traffic arriving on port2 on FortiSwitch is tagged with VLAN ID 10 and destined for PC1 connected on port1. PC1 expects to receive traffic untagged from port1 on FortiSwitch.
Which two configurations can you perform on FortiSwitch to ensure PC1 receives untagged traffic on port1? (Choose two.)

Question17: Which interfaces on FortiSwitch send out FortiLink discovery frames by default in order to detect a FortiGate with an enabled FortiLink interface?

Question18: Which drop policy mode, if assigned to a congested port, will drop incoming packets until there is no congestion on the egress port?

Question19: Which statement about the configuration of VLANs on a managed FortiSwitch port is true?

Question20: Which is a requirement to enable SNMP v2c on a managed FortiSwitch?

Question21: Refer to the diagnostic output:

Two entries in the exhibit show that the same MAC address has been used in two different VLANs. Which MAC address is shown in the above output?

Question22: Which two types of Layer 3 interfaces can participate in dynamic routing on FortiSwitch? (Choose two.)